Hi Dave
Thanks for the reply, I have always wondered what full page position was.... How would you sync the bed corners?
Colin
Search found 5 matches
- Tue Oct 04, 2011 11:31 pm
- Forum: Help or advice required please
- Topic: Is it possible for you to set an origin in newlydraw?
- Replies: 5
- Views: 5917
- Tue Oct 04, 2011 10:29 pm
- Forum: Help or advice required please
- Topic: Is it possible for you to set an origin in newlydraw?
- Replies: 5
- Views: 5917
Is it possible for you to set an origin in newlydraw?
Hi I have got a job to do with a 3020 running under the newlydraw software and I am tring to find out if it can be done. The items are plastic 60 x 40mm and 5mm heigh. We need to cut shapes into the plastic but they need to be centeral as one of the cuts is a circle 36mm which only leaves 2mm above ...
- Sun Nov 14, 2010 9:52 am
- Forum: General Discussion
- Topic: LS3020 & Newly Draw
- Replies: 5
- Views: 7342
Re: LS3020 & Newly Draw
Hi I have attached a sample. It measures 10 x 27mm at 1000dpi. It is engraved only. The problem I have is the letters com out so thin. Is there a better way of setting up the artwork? There is functions to produce slopes in ND they are not grayed out on the 3020 but don’t seem to do anything when en...
- Sun Nov 07, 2010 9:57 pm
- Forum: General Discussion
- Topic: LS3020 & Newly Draw
- Replies: 5
- Views: 7342
Re: LS3020 & Newly Draw
Ok erm did i mention i am new at this! I think raster.... I design the image in PagePlus X4 and save it as a jpg then import it into newly draw. I dont select anything else I just ask it to engrave. I have also been looking at the settings BOLD H and BOLD V these allow you to set 0 - 9 I have put 4 ...
- Sun Nov 07, 2010 8:43 pm
- Forum: General Discussion
- Topic: LS3020 & Newly Draw
- Replies: 5
- Views: 7342
LS3020 & Newly Draw
Hi We have been playing with the LS3020 and have gotten some good results. We do have a problem which i am hoping someone will have the answer. When we engrave from a jpg or any other image file the lines of the letters are really thin, is there any way we can specify the minimum width within newly ...