Laserscript user forum

Hi, I have recently upgraded my LS3060 to use Lightburn. Would anyone like to purchase the boards and dongle for laserscript ? £50.00

Hi, is there a way of making the laser a smaller diameter? I have been cutting 3mm ply recently, and the cut line is very wide. I set the gap from laser to ply as 78mm using the gauge that came with the machine. I have a 3060 with a 60 watt tube.

Hi, I have a 3060, my problem is raising and lowering the bed. I thought when you pressed Z if would start to lower and then after a couple of seconds it would start to go quicker. However after a couple of seconds mine just stopps and then I have to take my finger of the button and start again. to ...

Dave, Hi many thanks for the reply, It is an LS 3060 with 60w tube, engraving isn't too bad, I am getting quite a good result, it is cutting I am having problems with, I am getting a lot of burning underneath. no matter how low I set the laser, it still seems to go through too far, until the point w...

Hi,
Can anyone advise me on the settings I should be using for cutting and engraving 8mm acrylic please ?
Many thanks for your help.
Gordon.

Hi, Many thanks for the reply. To raise it off the bed, I use a plastic honeycomb that I found on line that is used for aquariums. It seems to work well, and it comes at the same size as the laser bed. The sooner I get the laser cut right, the longer it will last and not be cut right through. Thanks...

Hi lovely people. I have been doing trials with 3mm acrylic sheet, and have found that I only need 35% power to cut nicely and that still cuts through the plastic matrix I use underneath it, any more and I get ragged edge underneath. Can this be correct? Also, can you tell me why the laser doesn't f...

Hi, Many thanks for that, I looked and it was set to 100.00000. So I have set it to 80.00000 and will try it tomorrow. I am very pleased with myself today, I designed a gauge for my woodturning in Adobe Illustrator and managed to export it and bring it in to Lasercraft. I cut it out in 3mm acrylic a...

Hi,
It was created in Lasercut purely as a test for me to see what power and speed settings I am going to use.

Hi,
Can anyone help please When cutting out a Square, the laser dwells in the corners and burns a hole. Have I got a setting wrong? I have tried turning the power down, but it won't fire under 20%.
Thanks in advance.
Gordon