Hi All,
The machine has degraded over time. Cutting plywood I'm getting what I'd call excessive flaming and sparks (More than I used to get). Is this symptomatic of the tube wearing out? It's also charring the edges quite badly, power has dropped off a smidgen. Optics are clean and alignment OK.
Smoking/sparking
Re: Smoking/sparking
Check if the air assist is ok and all the power settings are ok before eliminating the tube!
Best
Dave
Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Who is online
Users browsing this forum: Ahrefs [Bot] and 10 guests