Quartz Worktop

Moderator: Admin

Dynamode
Posts: 18
Joined: Wed Jan 22, 2014 8:04 am
Contact:

Quartz Worktop

Postby Dynamode » Tue May 22, 2018 8:04 pm

Hello,

Can anyone tell me if you can Laser Etch Quartz, I have some off cuts of Worktop.

Has anyone tried it and what sort of results did you get.

Thanks for and advice.

Dynamode.

Daven
Posts: 1327
Joined: Fri Oct 15, 2010 6:44 pm
Location: Devon
Contact:

Re: Quartz Worktop

Postby Daven » Wed May 23, 2018 7:57 am

As far as I know you can but it may take slow speed and high power especially if it is light in colour. All I have done is slate!

Obviously be careful with any dust - doubt it will do you any good or the machine!

Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC


Return to “General Discussion”

Who is online

Users browsing this forum: No registered users and 4 guests