Hello to you all
we have just taken delivery of an LS2515 and waiting for it to be hooked up, i will be no doubt asking for advice as we are from the world of CNC routers.
One question i have is about adhesive tape backing, i am looking at pre applying a film to the back of perspex so that the letters come pre glued when cut.
Anyone suggest a wide-ish film non PVC obviously.
Martin
Good afternoon
Re: Good afternoon
http://www.tmbelectronics.com - Electronics, tools, hobby tools, power tools, and much more!
An ex LS3020 user now playing with an LS6840PRO (60W) and an LS1290PRO (80W)
An ex LS3020 user now playing with an LS6840PRO (60W) and an LS1290PRO (80W)
Re: Good afternoon
Hi Martin,One question i have is about adhesive tape backing, i am looking at pre applying a film to the back of perspex so that the letters come pre glued when cut.
I have tried this and whilst not all double sided sticky tape is the same, I found that the Perspex vaporises OK but the sticky tape caused a heat build up creating a slightly raised lip to the cut edges on the rear surface of the Perspex. Although hardly noticeable this did impair the quality of the bond when subsequently fitting the letters so I reverted back to using adhesive.
Tweakie.
Who is online
Users browsing this forum: No registered users and 10 guests