Hello from Duncan

Moderators: HPC, Daven

Post Reply
Derwentlaser
Posts: 1
Joined: Sun Feb 09, 2014 11:11 am
Contact:

Hello from Duncan

Post by Derwentlaser »

Hello, I stumbled across this forum and as I have a problem with my 6090 I wonder if anyone can help out?

When engraving I tend to get a double image everywhere except the outer edges of the engraving area. If I change it to engrave in one direction then it's fine, but things obviously take longer.
Any suggestions?

I look forward to hearing from you

Duncan
Spooky
Posts: 1291
Joined: Mon Apr 26, 2010 10:17 pm
Contact:

Re: Hello from Duncan

Post by Spooky »

sounds like scatter Dunc, check that the beam is exiting the center of the cone.

cheers

Dave
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Dave@OpticalPower.co.uk
Post Reply

Who is online

Users browsing this forum: No registered users and 3 guests