I'm pretty sure it did when I got it but my laser running NewlyDraw no longer returns to the top left position when I turn it on.
As a workaround I unlock the head and move it manually before moving to my zero position in software.
It's not the end of the world but it is slightly annoying. Anyone any clue as to what might cause this?
HX3040 not homing on power up
Re: HX3040 not homing on power up
On the general properties screen - check 'Pos' is set to 'Now TopLeft' and 'After all' is 'Back'
I can't think of any other options but it has been a long time since using a 3020
Best
Dave
I can't think of any other options but it has been a long time since using a 3020
Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Who is online
Users browsing this forum: No registered users and 10 guests