HX3040 not homing on power up

Moderators: HPC, Daven

Post Reply
gavspav
Posts: 16
Joined: Tue Jan 31, 2017 10:40 pm
Contact:

HX3040 not homing on power up

Post by gavspav »

I'm pretty sure it did when I got it but my laser running NewlyDraw no longer returns to the top left position when I turn it on.

As a workaround I unlock the head and move it manually before moving to my zero position in software.

It's not the end of the world but it is slightly annoying. Anyone any clue as to what might cause this?
Daven
Posts: 1632
Joined: Fri Oct 15, 2010 6:44 pm
Location: Devon
Contact:

Re: HX3040 not homing on power up

Post by Daven »

On the general properties screen - check 'Pos' is set to 'Now TopLeft' and 'After all' is 'Back'

I can't think of any other options but it has been a long time since using a 3020 ;)

Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Post Reply

Who is online

Users browsing this forum: No registered users and 8 guests