Double lines on cutting

Moderators: HPC, Daven

Post Reply
Daven
Posts: 1632
Joined: Fri Oct 15, 2010 6:44 pm
Location: Devon
Contact:
Contact Daven

Re: Double lines on cutting

Post by Daven »

Well done. Once you have the alignment set try not to disturb the mirrors - clean them in the holders (except for the one in the head) - I have just fitted a new tube and they were still spot on ;)

Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Top
Post Reply

Return to “Help or advice required please”

Who is online

Users browsing this forum: Semrush [Bot] and 2 guests