Hi, I was wondering if anyone could help,
I’ve been asked to engrave on a round bit of pine. I’ve never used pine, it’s usually ply or other woods.
I did a little test on a bit of pine I had and it’s left lines which looks like the grain in the wood.
Does this normally happen with pine? I grabbed some ply and tried it and that came out fine.
I’m not sure how to attach a pic? I hope this makes sense.
Thanks.
Engraving pine
Re: Engraving pine
Yes - pine does that - you could try increasing the scan gap to see if it helps.
Best
Dave
Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Re: Engraving pine
Thank you,
i’ll Have a try tomorrow.
i’ll Have a try tomorrow.
Who is online
Users browsing this forum: Semrush [Bot] and 4 guests