Hello, I stumbled across this forum and as I have a problem with my 6090 I wonder if anyone can help out?
When engraving I tend to get a double image everywhere except the outer edges of the engraving area. If I change it to engrave in one direction then it's fine, but things obviously take longer.
Any suggestions?
I look forward to hearing from you
Duncan
Hello from Duncan
-
- Posts: 1
- Joined: Sun Feb 09, 2014 11:11 am
- Contact:
Re: Hello from Duncan
sounds like scatter Dunc, check that the beam is exiting the center of the cone.
cheers
Dave
cheers
Dave
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Dave@OpticalPower.co.uk
Dave@OpticalPower.co.uk
Who is online
Users browsing this forum: No registered users and 2 guests