Good Day Everyone!
Took the plunge before Christmas and bought a LS3020 LSCT. Hoping to use it for a bit of modelling, crafting and maybe even a bit of manufacture trialling (obviously would need to upgrade before trying a real commercial bid)
So, 1000 Apologies in advance if you see some real idiot questions for the next few weeks.
Intend to set it up and do my first cut this weekend (probably try and download something basic (i see some kind folks have shared some of their work) for lasercut, just to trial it and get the end-to-end gist of it, as there is obviously a LOT to learn
Cheers in advance
Ky
Hello World
Re: Hello World
Hi Ky,
Welcome to world of lasers!
Don't worry about asking daft questions most of us have done the same in the past (or wished we had)
Best
Dave
Welcome to world of lasers!
Don't worry about asking daft questions most of us have done the same in the past (or wished we had)
Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Re: Hello World
Thanks Dave!!
Who is online
Users browsing this forum: No registered users and 0 guests