Hello All,
Here's a new one on me. One of my 3060s now insists on starting every cut from the top right.
It doesn't matter whether I set a design to "immediate" mode or leave the box unticked for "absolute" positioning. It ALWAYS returns to the top right to start the next job.
I've reloaded the firmware, presuming that some setting has corrupted. YET IT STILL HAPPENS! Even on a design left in memory that I KNOW used to cut in immediate mode.
What's happening? Some totally dumb menu option I haven't spotted?
Cheers,
James
3060 stuck in "absolute" positioning mode!
Re: 3060 stuck in "absolute" positioning mode!
Unh! Yes, indeed! It is that obvious.
I accidentally hit "SET LOGIC ORG" on the keypad. That means "Set logical origin" which does that. Going into "CANCEL LOGIC ORG" on the keypad and pressing "Yes" sorts the machine out again.
It's only taken me five years to work out what that setting is.
Cheers,
James
=====
I accidentally hit "SET LOGIC ORG" on the keypad. That means "Set logical origin" which does that. Going into "CANCEL LOGIC ORG" on the keypad and pressing "Yes" sorts the machine out again.
It's only taken me five years to work out what that setting is.
Cheers,
James
=====
Re: 3060 stuck in "absolute" positioning mode!
There is no logic to logic sometimes
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Who is online
Users browsing this forum: No registered users and 3 guests