Ls6040 focus tool lost
Ls6040 focus tool lost
Hi, I have lost my focus tool that I got when I got my laser and wondered if anybody knew the size of the acrylic square that is supplied? Also The red light bracket came loose and now I am not sure whether the settings are all out as I cannot cut through 3mm ply non the setting I usually use. Help please...
Re: Ls6040 focus tool lost
Hi - it may depend on the build - 78mm or 85mm if the same as the 3060 - the focal length of the lens is 50.1mm so you can get a rough idea from the lens to the surface.
The red light should not change any of the alignments - it is really just a guide for where the laser will start cutting - more likely to be the focus.
If you get stuck call HPC or do a ramp test - should be explained on here somewhere
Best
Dave
The red light should not change any of the alignments - it is really just a guide for where the laser will start cutting - more likely to be the focus.
If you get stuck call HPC or do a ramp test - should be explained on here somewhere
Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Who is online
Users browsing this forum: Ahrefs [Bot] and 0 guests