Hello,
Has anyone out there been using Mirror Perspex, if you have, what sort of results have you had and what settings have you used to cut and etch.
Thanks in advance for any replies.
Dynamode
Mirror Perspex
Re: Mirror Perspex
I do - cuts about the same as normal Perspex so around 20mm/s at 70% on a 60w. Etch depends how deep you want but 200 at 30% 300dpi would be a good place to start 
Best
Dave
Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Re: Mirror Perspex
What thickness is that for Dave ?
Re: Mirror Perspex
3mm
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Re: Mirror Perspex
Ta 
I've not cut much plastic as I don't like the smell .. like , you can smell it for miles !
I have some Mirror stuff, think its thinner than that. .. been a while since I cut any though
I've not cut much plastic as I don't like the smell .. like , you can smell it for miles !
I have some Mirror stuff, think its thinner than that. .. been a while since I cut any though
Re: Mirror Perspex
Good results with 3mm acrylic here.
Who is online
Users browsing this forum: Ahrefs [Bot] and 1 guest