New User
Posted: Thu Apr 07, 2016 8:31 pm
Hi All
Thought I would sign up and say hello
I have recently purchased a LS3020 and so far (fingers crossed) everything seems to be working ok and I have got some acrylic cutting and the finish is quite good.
Few questions if anyone can help me as I am sure there are a few Guru's out there
1. The machine doesnt seem to have a focus ruler/tool so does anyone have a drawing or measurements so I can make one or know where I can purchase one?
2. When engraving on the perspex, the engraving is very fine/light and not very prominent. Does that mean I have to run 2 cycles at the required settings?
3. I use AutoCad to draw my files but when importing into Newlydraw, the file is huge and I have keep scaling it down to size so is there a setting I can alter so that when its imported, its exactly the same size as when drawn in AutoCad?
Thanks and I am sure I will have a load more questions too at some point!
Rich
Thought I would sign up and say hello
I have recently purchased a LS3020 and so far (fingers crossed) everything seems to be working ok and I have got some acrylic cutting and the finish is quite good.
Few questions if anyone can help me as I am sure there are a few Guru's out there
1. The machine doesnt seem to have a focus ruler/tool so does anyone have a drawing or measurements so I can make one or know where I can purchase one?
2. When engraving on the perspex, the engraving is very fine/light and not very prominent. Does that mean I have to run 2 cycles at the required settings?
3. I use AutoCad to draw my files but when importing into Newlydraw, the file is huge and I have keep scaling it down to size so is there a setting I can alter so that when its imported, its exactly the same size as when drawn in AutoCad?
Thanks and I am sure I will have a load more questions too at some point!
Rich