Page 1 of 1
Hi Everyone
Posted: Thu Oct 27, 2016 1:47 pm
by gsace
Just bought a HPC 3020. Huge learning curve to go through so that I can use it. I've only used a Craft Robo/Silhoutte Cameo before so big difference. Looking forward to reading the forum to get some hints and tips on how best to use the machine.
Re: Hi Everyone
Posted: Thu Oct 27, 2016 1:57 pm
by Daven
Hi - welcome
Best
Dave
Re: Hi Everyone
Posted: Fri Oct 28, 2016 8:42 am
by Lightnin
Howdy
if you've used the Cameo and similar you are more than half way there.
You'll have to learn the laser power and speed etc. but the software/design/layout will be similar.
Maybe even the same depending on how you usually design.