Laser strength going?
Posted: Fri Mar 27, 2020 8:15 am
Good morning, I have recently had a service (which was great may I add)
However now we're all in quarantine I thought I would use the laser a bit more... I have noticed that when cutting its cutting fine on half the bed and then invisible on the other side like the power is cutting out.... If I am doing multiple of the same thing I often make a template and just keep adding the parts on top, like a square for example... 4 squares are fine and then 2 the laser will go over it but just leaves no mark...
Please advice.
Many thanks
Matt
However now we're all in quarantine I thought I would use the laser a bit more... I have noticed that when cutting its cutting fine on half the bed and then invisible on the other side like the power is cutting out.... If I am doing multiple of the same thing I often make a template and just keep adding the parts on top, like a square for example... 4 squares are fine and then 2 the laser will go over it but just leaves no mark...
Please advice.
Many thanks
Matt