Hi everyone, this is my first time posting here. Hope you are all safe and well.
I work at a design agency and amongst all our equipment we have a hpc laser cutter that I have been trying to get going. We moved premises and I was given the task of getting it all set up again.
I have everything set up and ready to go, done some test files but having problems with inconsistent engraving and cutting results across the bed.
I have attached pictures of the results here:
Do you think this could be a mirror alignment issue? It seems as if the engraving changes strength across the bed of the machine?
Any help would be great?
Thanks
Matt
Advice needed regarding cutting and engraving
-
- Posts: 5
- Joined: Fri Oct 30, 2020 7:51 am
- Contact:
-
- Posts: 5
- Joined: Fri Oct 30, 2020 7:51 am
- Contact:
Re: Advice needed regarding cutting and engraving
(The idea was to do one of these cards for each speed as a reference)
Re: Advice needed regarding cutting and engraving
Yes - typical issue when bed is not level of mirrors out. Check bed is level with the ruler tool in each corner of the bed first then move to the mirrors.
Best
Dave
Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Who is online
Users browsing this forum: No registered users and 0 guests