Test Button Query

Moderators: HPC, Daven

Post Reply
PeterB
Posts: 14
Joined: Sat Jun 21, 2014 2:45 pm
Contact:
Contact PeterB

Test Button Query

Post by PeterB »

Usually before I run a job I press the "TEST" button to make sure my material is in the correct place, sometimes when pressing the TEST button nothing happens. Is this usual ?
I use a LaserScript 600x900 60watt
Peter
Epilog Zing16 40watt, LaserScript 600x900 60watts, Active3D printer. Photoshop, Corel Draw X6, PhotoGrav, Adobe Lightroom http://www.reynarddesign.co.uk
Top
Daven
Posts: 1632
Joined: Fri Oct 15, 2010 6:44 pm
Location: Devon
Contact:
Contact Daven

Re: Test Button Query

Post by Daven »

Yes - it depends on the mode it is in - I tend to hit the esc key before anything else ;)
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Top
Tom
Posts: 322
Joined: Mon Sep 19, 2011 6:15 pm
Contact:
Contact Tom

Re: Test Button Query

Post by Tom »

Hi Peter

If it still has the time on the screen it will not test.
Just press ESC

Tom
Top
PeterB
Posts: 14
Joined: Sat Jun 21, 2014 2:45 pm
Contact:
Contact PeterB

Re: Test Button Query

Post by PeterB »

Ok, thanks.
Epilog Zing16 40watt, LaserScript 600x900 60watts, Active3D printer. Photoshop, Corel Draw X6, PhotoGrav, Adobe Lightroom http://www.reynarddesign.co.uk
Top
PeterB
Posts: 14
Joined: Sat Jun 21, 2014 2:45 pm
Contact:
Contact PeterB

Re: Test Button Query

Post by PeterB »

Test button works every time now, many thanks
Epilog Zing16 40watt, LaserScript 600x900 60watts, Active3D printer. Photoshop, Corel Draw X6, PhotoGrav, Adobe Lightroom http://www.reynarddesign.co.uk
Top
Post Reply

Return to “General Discussion”

Who is online

Users browsing this forum: No registered users and 3 guests